CAD/CAM Robotics and Factories of the Future ’90

CAD/CAM Robotics and Factories of the Future ’90

4.11 - 1251 ratings - Source



According to the Concurrent Engineering Research Center (CERC) at West Virginia University, qthe concurrent engineering (CE) is a rapid simultaneous approach where research and development, design, manufacturing and support are carried out in parallelq. The mission of concurrent engineering is to reduce time to market, improve total quality and lower cost for products or systems developed and supported by large organizations. The purpose of the concurrent design methodology is to let the designer know the consequences of his design decisions in the manufacturing and assembly stages as well as in subsequent operations. Design for manufacture and assembly, design for reliability and testability, CAD/CAM/CAE, knowledge based systems, cost analysis and advanced material technology are the major constituents of concurrent engineering. The need for concurrent engineering can be justified from the fact that in every production cycle, the design phase approximately takes 5 to 10% of the total cycle, but overall it influences 80% of the production cycle. This volume contains articles from a wide spectrum dealing with concepts of concurrent engineering. The importance of the knowledge-based systems in the CE environment is significant as they provide the common platform to achieve the same level of expertise to the designers and manufacturers throughout the organization for the specific task. Their role in qdo it right the first timeq is very important in providing aid to the designers and manufacturers to optimize the design and manufacturing setups for a cost effectiveness and reduced production time.PCB. Manufacturability. and. Assembly. Introduction Expert systems have been found very useful in todaya#39;s industry. ... The post processor operates on a CAD file to produce the Cartesian locations of the electronics component as specified by the designer and ... A discrete optimization assembly method for an automated workcell is described in the fifth paper. ... The problem is formulated as a non- linear optimization problem with linear objective function and quadratic constraints.


Title:CAD/CAM Robotics and Factories of the Future ’90
Author: Suren N. Dwivedi, Alok K. Verma, John Sneckenberger
Publisher:Springer Science & Business Media - 2012-12-06
ISBN-13:

You must register with us as either a Registered User before you can Download this Book. You'll be greeted by a simple sign-up page.

Once you have finished the sign-up process, you will be redirected to your download Book page.

How it works:
  • 1. Register a free 1 month Trial Account.
  • 2. Download as many books as you like (Personal use)
  • 3. Cancel the membership at any time if not satisfied.


Click button below to register and download Ebook
Privacy Policy | Contact | DMCA